Filter
Top Products
4-EN
Detaching the Front Panel
1 Press the POWER button to turn off the power.
2 Press the (Release) button until the front
panel pops out.
3 Grasp the left side of the front panel and pull it
out.
NOTES
• The front panel may become hot (especially the
connector terminals), this is not malfunction.
• To protect the front panel, place it in the supplied
carrying case.
Attaching the Front Panel
1 First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projection on the main unit.
2 Push the left side of the front panel until it locks
firmly into the main unit.
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
• Connectable to Remote Control Interface
Box
You can operate this unit from the vehicle's
control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.
Initial System Start-Up
1 Immediately after installing or applying power to
the unit, it should be initialized. To do this, first,
remove the detachable front panel. Behind the
front panel, to the right of the connector, there is
a small hole. Using a ballpoint pen or other
pointed object, press the RESET switch mounted
behind this hole to complete the initialization
procedure.
Basic Operation
2
c
1
1
2
1
1
POWER/SETUP
RESET Switch
MODE/LOUD