Filter
Top Products
EN
5-EN
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off.
Press the POWER button again to turn off the
unit.
NOTE
When the power is turned on for the very first time after
the unit is connected to the vehicle's battery, the unit
produces sound with the volume level 12, loudness on in
the tuner mode.
Non Fading Pre-out (N.F.P.) On and
Off (TDM-7583R only)
1 Press and hold the Eject (c) button for at least 3
seconds.
With each press, N.F.P. is toggled On or Off.
N.F.P. ON:
In this position, the Pre-Output on the TDM-
7583R will not be affected by the fader. This is
ideal for driving a subwoofer amplifier.
N.F.P. OFF:
Returns to normal fader mode.
NOTES
• Initial mode is N.F.P. OFF.
• Set the N.F.P. to OFF unless the subwoofer is used.
Adjusting Source Signal Levels
If the difference in volume level between the tape
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the Preset 1 button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and tape player
closer.
Each press toggles between FM-LV HI and FM-
LV LO.
3 Press the SETUP button to cancel the adjusting
mode.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right
Channels)/Fader (Between Front
and Rear Speakers)
1 Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
NOTE
If the 6 or 5 button is not pressed in 5 seconds after
selecting the BASS, TREBLE, BALANCE and FADER
modes, the unit automatically sets in the VOLUME mode.
2 Press the 6 and 5 buttons until the desired
sound is obtained in each mode.
NOTE
The settings of the Bass and Treble will be individually
memorized for each source (FM, MW, LW, Tape and CD
Changer) until the setting is changed.
Depending on the connected devices, some functions and
display indications do not work.
Turning Loudness On/Off
1 Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness
mode. The display shows "LD" when the
loudness mode is activated.
→ VOL → BASS → TREB
FAD ← BAL ←