Filter
Top Products
12
High Frequency Driver replacement continued:
10
10
This is what the high frequency
driver looks like removed from
the horn assembly. Four headless
screws need to be removed from
the driver. Pliers could help if the
screws are too tight. Turn counter-
clockwise to loosen and remove,
clockwise to tighten.
11
11
Keep the four headless screws in
a safe place. Place the new high
frequency driver (part #0008093)
where the old one was by following
the same steps as above, but
backwards 10 to 1. Power up the
S225 and the new driver should now
be pumping out those highs again.
Fantastic, you just replaced a high
frequency driver!
1
1
3
3
2
2
4
4
1
1
3
3
2
2
4
4