Filter
Top Products
©American Audio® - www.AmericanAudio.us - DLS 15™/DLS 15P™ - Instruction Manual Page 15
D
LS 15™/
D
LS 15P™ Rigging and Mounting Options
Speaker Rigging Hardware – The DLS 15™ and the DLS 15P™ may be permanently installed
or mounted using any of the many available third party wall brackets and ceiling mounts available.
Always be sure to follow all safety instructions and guidelines included with the mounting hardware
for safe and proper installation. American Audio
® carries an assortment of rigging hardware specially
designed to work with the DLS 15
™ and the DLS 15P.™ The Z-APX/B is a heavy-duty bolt and may
be used to secure the speaker to a cable or chain. The Z-APX/H is a heavy-duty eyebolt and is used
to suspend or secure the speaker using safety cables. Please contact your dealer for more informa-
tion and availability.
Rigging Points – The DLS 15™ and the DLS 15P™ include four
rigging points. These points are detailed on page six. The rigging
points are used to “fly” or suspend the speaker in the air by some
means.
Pole Mounting – The DLS 15™ and the DLS 15P™ also include a
pole mount option. The pole mount socket located on the bottom of the
speaker may be used to secure the speaker to a speaker tri-pod, such as
the American Audio
® SPS-1B as illustrated on the left. Always be sure to
follow the guidelines listed below when pole mounting your speaker;
• Always be sure the stand is designed to support the weight of
the speaker
• In outdoor situations that are prone to windy conditions and
strong wind gust, be sure to use sandbags as additional tri-pod
support, this will greatly reduce the risk of tipping
• Do not stack speakers on top of each other when mounting on
a tri-pod. Only one speaker should be mounted to a tri-pod at one
time.
• Always position the tri-pod legs away from foot traffic
• Extend the tri-pod legs to their fully extended position to avoid
accidental tipping
• Observe and follow all safety guidelines and regulations specified
by the tri-pod’s manufacturer
• Be sure the tri-pod is situated on a flat, level, and stable surface
• Always tighten all tri-pod locks
Pole Mount Locking Screw – This screw is located on the rear of
the speaker and is attached to the pole mount socket. Always use this
screw to secure the speaker in place when mounting this speaker in a
pole mount configuration. Always be sure to tighten down on this screw
to prevent the speaker from shifting directions during use.