Filter
Top Products
©American Audio® - www.AmericanAudio.us - DLS 15™/DLS 15P™ - Instruction Manual Page 9
D
LS 15™/
D
LS 15P™ Rear Panel Controls and Features
Rear Panel Cont.:
stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE
inputs. Do not connect mixers to this input, use the Balanced XLR or RCA Input (18 or
19) only!
15. MICROPHONE 2/LINE LEVEL INPUT LEVEL – This knob is used to regulate the output signal
of the microphone and/or cd player/tape deck that is connected to the Mic/Line Level 2 Input
Jack (15 & 17).
16. 1/4” MIC 2/LINE LEVEL INPUT JACK – This jack is used for a Microphone and Line Level
inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with
stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE in-
puts.
17. LINE LEVEL INPUT VOLUME – This knob is used to regulate the output signal of the line level
source connected to the Line Level Input Jacks (18 & 19).
18. BALANCED XLR LINE INPUT – This connection is designed to accept a balanced line input
signal from a mixer or other line level device with a balanced output jack. Use a balanced cable
when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be sure to
connect only line level input devices such as mixers and tape machines to this jack.
19. BALANCED RCA LINE INPUT – This connection is designed to accept a balanced line input
signal from a mixer or other line level device with a balanced output jack. Use a balanced cable
when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be sure to
connect only line level input devices such as mixers and tape machines to this jack.
20. OUTPUT VOLUME – This knob is used to regulate the output signal being sent to another DLS
15P™ or other line level input jacks such as a mixer or power amp. (22 & 23).
21. XLR PARALLEL OUTPUT JACK – This jack is used to send the incoming line level signal from
either of the Line Level Inputs Jacks to another DLS 15P™ or other line level input jack such
as a mixer or power amp.
22. 1/4” LINE OUTPUT JACK – This jack is used to send the incoming line level signal from either
of the Line Level Inputs Jacks to another DLS 15P™ such as a mixer or power amp.
23. TREBLE CONTROL – This knob is used to regulate the amount treble applied to the output sig-
nal. The maximum amount of treble gain is +12dB and the maximum amount of treble decrease
is -12dB. Turning the knob in a counter-clockwise direction will decrease the amount of treble
applied to a channel signal, turning the knob in a clockwise direction will increase the amount
of treble applied to a channel signal.
24. BASS CONTROL – This knob is used to regulate the amount bass applied to the output sig-
nal. The maximum amount of bass gain is +8dB and the maximum amount of bass decrease
is -12dB. Turning the knob in a counter-clockwise direction will decrease the amount of bass
applied to a channel signal, turning the knob in a clockwise direction will increase the amount
of bass applied to a channel signal.
25. CLIP L.E.D. - When your Mic 1/Mic 2, Line Level or Speaker Levels are distorted or too loud
this L.E.D. will light letting you know to adjust
your volume level to a lower setting.
26. POWER LED - This L.E.D. will be lit when you switch on the power.