Filter
Top Products
P/N 47-655-12
.
03/97
Ampeg reserves the right to change specifications without notice.
Ampeg is proudly Made in America. ©1996 SLM Electronics, 1400 Ferguson Avenue, St. Louis, MO 63133 U.S.A.
SVP-1500 Bass Amplifier
Technical Specifications
POWER OUTPUTS (per channel, stereo mode)
1,2
2 ch (20-20kHz) 2 ch 1kHz 2 ch 40Hz (1 cycle) 1 ch 1 kHz 1 ch 40Hz (1 cycle)
8 ohms: 230 watts 260 watts 280 watts 295 watts 300 watts
4 ohms: 425 watts 480 watts 500 watts 550 watts
2 ohms: 560 watts 780 watts 750 watts 900 watts
POWER OUTPUTS (mono mode)
1,2
20-20kHz 1kHz 40Hz (1 cycle)
16 ohms: 460 watts 520 watts 560 watts
8 ohms: 850 watts 960 watts
4 ohms: 1120 watts 1560 watts
FREQUENCY RESPONSE +0, -.8dB / 20Hz - 20kHz @ 230 W / channel @ 8 ohms
TOTAL HARMONIC DISTORTION Less than .25%, 20Hz - 20kHz @230 W / channel @ 8 ohms
SLEW RATE
1
30 volts / microsecond (stereo mode), 60 volts / microsecond (mono mode)
SIGNAL TO NOISE RATIO
1,2
Greater than -100dB from 230 watts / 8 ohms
INPUT TYPE AND IMPEDANCE Transformerless electronically balanced, 20K actual load impedance. Suitable for Low or
High-Z balanced line. One (1) 1/4” phone jack per channel.
INPUT SENSITIVITY 1.5 V RMS for 230 Watts / 8 ohms
LOAD IMPEDANCE Stereo Mode: 2 ohms or greater; Bridged Mono Mode: 4 ohms or greater
DAMPING FACTOR
1
Typical 250 (1kHz, 8 ohms)
OUTPUT CONNECTIONS 1/4” phone jack*, plus Speakon
®
jacks each channel; Speakon
®
jack for Mono Bridge/Biamp
PROTECTION CIRCUITRY Short circuit, RF burnout, overtemp, turn on/off transient and DC protection, Speaker protection
relays, built-in auto limiter (Anti-clip)
COOLING Forced air fan cooling, rear intake, front exhaust
POWER REQUIREMENTS 115VAC 60Hz, 880VA
100/110VAC 50/60Hz, 880VA
230VAC, 50/60Hz, 880VA
CIRCUIT BREAKER 10 amp (mains)
SIZE AND WEIGHT 19” W x 5.25” H x 12.5” D; 33 lbs. 483mm x 133mm x 317mm; 15Kg.
1
typical performance
2
@115 VAC 60Hz
*NOTE: 1/4” jacks not available in some areas.