Filter
Top Products
Installation
30
7" Modero Widescreen Touch Panels
Removing the Internal Faceplate from the panel exposes the pushbuttons and light pipes along
the inside of the Internal Faceplate.
4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to
remove it from the Faceplate (FIG. 30).
5. From along the internal surface of the Faceplate, remove the six buttons by gently bending
each Button latch up and pulling the button outwards.
6. Remove the pair of clear light pipe strips by bending the two black light pipe latches inwards
and pulling out the strip.
7. Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside
surface of the Faceplate (made available by the removal of the previous Trim Ring).
8. Gently insert the Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 31).
9. Firmly press down around the No-Button Trim Ring until all of the latches are securely
inserted into their openings on the Faceplate, and the No-Button Trim Ring is securely
fastened. Verify the No-Button Trim Ring is firmly inserted onto the Faceplate and that there
are no gaps between this Trim Ring and the outer surface of the Faceplate.
10. Place the Faceplate back onto the main NXD-CV7 unit. Make sure to align the Microphone,
Light, and PIR Motion sensor locations on the main unit to their respective openings on the
Faceplate assembly.
FIG. 30 Removing the default Button Trim Ring
Default Button Trim Ring
Tr im
(with button openings)
B
Faceplate
CV7 Panel/enclosure
Ring
Latches
Button latch
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the internal surface of Faceplate)
(outside surface shown)