Filter
Top Products
Installation and Wiring
17
VTM-D15/A 15" MultiMedia Touch Panel Systems
5. The VTM-D15/AB panel should now be mounted on the surface/wall using the secured
VTM-WMB bracket as shown in FIG. 15.
Connecting the cables on a VTM-D15/AB surface mount panel
1. Connect the VGA Input, Touch Screen Signal, and Power cables to the VTM-D15/AB touch
panel as shown in FIG. 11.
2. Once the installation of the Wall Mount Bracket (VTM-WMB) and the connection of the
appropriate cables has been finished, follow the steps in the Wiring the AXB-TPI/3 section on
page 18.
FIG. 15 Rear of VTM-D15/AB shown with attached VTM-WMB bracket
FIG. 16 Attaching the cables to the rear of the VTM-D15/AB
Surface Mount bracket (on wall)
Monitor Mount bracket (on panel)
Rear view of panel (as seen from wall)
VGA Input cable - connects from panel
to Monitor Out port on TPI/3
Touch Screen cable - connects
from panel to Mouse Port on TPI/3
12 VDC connector - routes
power from the power cord and
adapter
Power Adapter
12 VDC
input
VTM-WMB
Wall Mount
Bracket
Do not plug in the power cord to the Power Adapter at this time. Power is supplied
after the entire system is wired together. Refer to the Connecting the MultiMedia
Components section on page 20 for powering procedures.