Filter
Top Products
Page - 6 Operator Manual – KLR Series Amplifiers
Copyright© 2010 – Ashly Audio Inc.
Installation
KLR-Series amplifiers are designed for use in both fixed and mobile sound systems. Each
amplifier is shipped (unless otherwise specified) with the following factory settings:
Front panel: Rear panel:
On/Off Switch = Off
Attenuators = ∞
High Pass Filter(s) = Off
Gain Selector = +26 dB
Mode Selector = Stereo
Limiter Switch = Off
Before connecting to mains power, make sure that the switches are set to the configuration
needed for your particular application. Always switch the amplifier off before making any
changes to the settings. Failure to do so could result in damage to the unit or other components
in your system. CAUTION: When mounting or connecting the amplifier, always disconnect it
from the mains. Use four screws and washers when mounting the amplifier to the front rack
rails. Rear support is also recommended, especially for mobile or touring use. To reduce the
risk of fire or electric shock, do not expose this apparatus to rain or moisture.
Requirements
KLR-Series amplifiers have specific physical, electrical and signal requirements for proper
operation. These requirements will vary depending on your specific application, setup, and
the settings on the amplifier. When setting up and testing your system, please take special
care to double check all connections and settings. Please refer to the specifications section
of this manual for specific input, output and other figures.
Installation Density
KLR-Series amplifiers produce substantial power output from a small chassis. When
driven at the higher-end of their potential, they do produce heat that must be dissipated. In
cases where multiple KLR amplifiers are mounted together (or a single KLR with other
equipment), it is recommended that a 1RU space is left between units to allow for proper
air circulation. If the amplifier overheats, it will go into ‘thermal’ protect mode to prevent
damage to itself and any connected components and speakers.
Important Safety
Instructions – 2
Introduction - 3
The KLR Series - 4
Physical Description - 5
Front Panel
Rear Panel
Installation – 6
Requirements
Installation Density
Typical Applications
Connectors & Polarity
Speaker Connections
Troubleshooting - 10
Spec Table - 11
Warranty - 12