Filter
Top Products
4
Controls & Connections (Rear)
RETURN
SEND - L
EFFECTS
LOOP
SEND - R
MODEL REACTOR 112
Atomic Amplifiers LLC.
Orange CT.
FUSE
0101010101
!CAUTION!
X
VOLTAGE SELECTOR SWITCH:
The Reactor 112 has a voltage selector switch and can be used in most countries. The switch
selects between 115Volts (US use) and 240Volts (European use). IMPORTANT! For use in the
United States the voltage selector switch should be set to the 115v setting at all times!
Y
AC LINE CONNECTOR:
Accepts a standard grounded AC cable.
Z
FUSE HOLDER:
The Fuse Holder houses the power fuse (see pages 15 &16)
[
RETURN:
The RETURN is unbalanced and provides an input directly to the Reactor’s amplifier. Inserting a
jack into the RETURN interrupts the signal from the left output feed from the DS-1. The RETURN
can be used as an outboard effect return (see page 7), or as the Reactor’s main input when using
rack or floor style modelers and not using the DS-1 (see pages 11,12 &13).
\
SEND – L & SEND – R
SENDS - L and R are unbalanced and are direct sends from the Left and Right outputs of the
modeler when housed in the DS-1 docking unit. SEND – L can provide a feed to outboard effects
devices or to a sound reinforcement or recording console (see page 8). SEND – L can be also be
used to feed signal to a second Reactor for “mono stacking” (see page 11). SEND – R is switched
so if engaged converts a modeler housed in the DS-1 for stereo output, SEND – R is used to send
your modelers right signal to a second Reactor for stereo operation. (See page 8 & 10). Please
note that SEND – L and SEND – R are proprietary to the DS-1 and are not operational when
using modelers or preamps outside of the DS-1. Those products should be used according
to their instruction manuals.
]
FAN:
The Reactor 112 comes equipped with a special “studio quiet” cooling fan.
^
SERIAL NUMBER:
Make sure to register your Reactor either by mailing your product
registration card, or by logging onto www.atomicamps.com
Z
^
[
\
X
]
Y