Filter
Top Products
9
Connecting the Receiver
To view programs broadcast in high definition, your receiver must be connected to a
suitable high-definition TV or computer monitor. Your receiver is also compatible with
standard-definition TVs.
Your receiver should have been connected to your TV by your installer. However, if you
need to disconnect and re-connect your equipment, please read the information in this
chapter carefully before you re-connect the receiver to your TV.
Before you begin:
• Do not connect your receiver (or any other equipment such as a TV or DVD player)
to the AC power supply until you have properly connected all the other cables.
• Disconnect your receiver from the AC power supply before you disconnect any
other equipment from its rear panel.
• To disconnect power from your receiver, always detach the power supply unit from
the wall electrical outlet (rather than removing the cord from your receiver). You
should install your receiver near a wall electrical outlet that is easily accessible.
• The TO WALL (VIDEO IN) connector is designed for connection to an HPNAv3 in-
home network over coaxial cable. You must not connect any other equipment to this
input.
• Any cable connected to the OPTICAL connector must be a fiber optic TOSLINK
connector, not a regular audio cable.
• If you are in any doubt about the power supply cord, its plug or its connection,
consult a qualified electrician.
• Use the TV remote to set the input to match the connector selected on the back of
the TV.