Filter
Top Products
3
IF VEHICLE IS NOT EQUIPPED WITH FACTORY REAR A/C AND REAR AUDIO CONTROLS,
PROCEED TO STEP 4.
1. Carefully remove the O.E.M. console mounted to
inner roof of vehicle by pulling downward on sides to
release clips. See Figure 1.
2. Lower console and disconnect wiring at (3) three locations.
Remove and retain controls from console and lay them in
a safe place. Discard console. See Fig. 2.
3. Remove and retain (2) two O.E.M. screws which
secure plastic panel. Slide panel rearward until front
edge of panel can be lowered through headliner.
Slide forward and discard panel. See Figure 3.
4. Using a razor knife, carefully trim headliner as shown.
Make sure the 27” cut is centered left to right in vehicle.
Caution: Before cutting headliner material,
check for wiring or other componentry above
headliner. Cut only where indicated.
DO NOT OVERCUT HEADLINER. See Figure 4.
5. Remove and retain O.E. dome light. Caution: Headliner
material is brittle. Use care when removing dome
light. Access dome light clip through opening
previously cut in headliner.
6. Scribe a center line on the sheet metal roof of vehicle.
FIGURE 1
FIGURE 2
URE 2
FIGURE 4
FIGURE 3