Filter
Top Products
I. PREPARATION OF VEHICLE INTERIOR
1. Remove and retain rear A/C controls by pulling
downward. Disconnect wire harness. See Figure 1.
Set controls in a safe place for reuse later.
FIGURE 1
2. Cut template (item 7 pg 2) in area #1. Locate and tape template to the headliner. Make sure template is
centered left to right in vehicle and mark area to
be cut. Remove template and trim headliner. Cut
template areas #2 & #3 and reinstall the template
to the headliner. Ensure area #1 of the template
hole locations are aligned with the OEM bracket
holes. Mark and trim headliner. The rear cutout
is critical, do not overcut or the opening will be
visible when the console is installed. See Fig. 2.
Caution: Before cutting headliner material,
check for wiring or other componentry above
headliner. Cut only where indicated.
FIGURE 2
3. Remove and retain O.E. A/C switch bracket and
screws. See Figure 3.
FIGURE 3
3