Filter
Top Products
18
OPTIONAL ACCESSORIES
WIRELESS HEADPHONES
The VOH1502 includes a built in Infrared
Transmitter for use with Audiovox Wireless
Headphones (P/N MVIRHS). Turning the
Headphone switch ON will activate the internal
IR Receiver, the volume can then be adjusted
using the controls on each headset. Any number
of wireless headphones can be used, but all
must be within a line of sight from the transmitter,
as infrared transmissions, like visible light travel
only in a straight line.
NOTE: AUDIOVOX Wireless Headphones (P/N
MVIRHS) are for use with the “A” channel only.
If both A and B channels are used, AUDIOVOX
Headphones (P/N IR2CHS) will be required.
The VOH1502 has a Jack labeled “to FM
Transmitter”, this Jack is for connection of an
optional Audiovox RF Transmitter (P/N
WTXRF01). This Transmitter is for use with the
Audiovox Wireless RF Headphones (P/N
WHPRF01).
Consult the documentation accompanying the
Audiovox Wireless Headphones for more
information.
WIRED FM MODULATOR (P/N FMM100)
Your video system may be equipped with an
optional RF modulator, that allows you to listen to
the VOH1502’s audio signal by tuning your
vehicle’s radio to the selected frequency, (88.7 or
89.1- check with your installer) and turning on the
remote mounted RF modulator switch. (In most
cases this toggle switch will be located
underneath the driver’s side of the dash, check
with your installer for the exact location.)
Whenever the RF Modulator is ON, broadcast
radio reception will be poor. Turning the remote
mounted toggle switch OFF will allow for normal
radio reception.