Filter
Top Products
4
II. PREPARATION OF CONSOLE FOR INSTALLATION
4. Turn console upside down and remove and
retain (15) fifteen T-15 TORX screws which
secure the cloth covered trim ring to console.
See Figure 4.
5. Turn console over and open both
compartment doors. Carefully separate the
console from trim ring. Remove electronic
compass from console and lay it in a safe place
for use later. Remove and retain velcro tape
and lay it in a safe place for later use. Discard
cloth covered trim ring.
See Figure 5.
6. Cut the orange and black wires from dome light.
Cut all wires 7” from tape where indicated.
See Figure 6.
FIGURE 4
FIGURE
5
FIGURE
6