Filter
Top Products
7
III. INSTALLATION OF CONSOLE
NOTE: Additional assistance in mounting the overhead console in vehicle is
advised to prevent damage to console or components.
12. Install and route all video and audio cables, and
any other added component requirements to
their respective places in the vehicle. Refer to
component installation instructions for wiring
diagrams. The suggested routing of the video
system cable is as follows: Above the headliner
from video system to B-pillar. Rearward to the
C-pillar. Down the C-pillar to the floor. Route
the power lead to an accessory controlled
source. Connect the ground lead to the vehicle
chassis. Route the remaining wiring (RCA
plugs, Remote Sensor extension, etc.) to the
VCP location. See Figure 11. Connect per
instructions included with the video system. If
video system if to be used as a television, install
an appropriate antenna per instructions
included with the antenna.
Caution: Do not overtighten screws. Use extra support for the console until secured to the
vehicle. Failure to do so may cause damage to console or installed components.
13. Raise console into approximate position and connect wiring to O.E. components.
14. Carefully position console against headliner.
Loosely install using (2) two 6-32 X 3/4"
screws (item 3 pg 2) through the smaller holes
in bracket on console into threaded clips on
mounting bracket.
15. Secure the front of console to the inner roof of
vehicle using original screw in original location.
See Figure 12.
16. Using an awl or similar tool, align the rear
mounting holes with holes in bracket. Apply
upward pressure to console and secure using (2)
two #8 x 3/4" screws (item 2 pg 2). See Fig. 12.
17. Tighten (2) two 6-
32 X 3/4" screws previously
installed in step 14.
FIGURE
11
FIGURE
12