Filter
Top Products
5
7. Mark a line on both sides of dome light as
close to the edge as possible. Using a band
saw or suitable tool, carefully trim console as
shown. Discard dome light. Note: If console
is trimmed too far away from dome light,
the trimmed edge may be visible when
installed in vinyl console. See Figure 7.
Installer’s option: Turn console over and place
on a padded surface. Trim console along ridge
on either side of dome light.
8. Install the electronic compass in original position
and secure using (2) two pieces of felt tape (item 7
pg 2). See Figure 8.
FIGURE
7
FIGURE
8