Filter
Top Products
Drill holes 1/8" (4mm) in diameter.
PROCEDURE FOR HORIZONTAL INSTALLATION
1
2
3
Bracket
Attach a mounting bracket to each side of the unit, using the
4 hex head bolts with washer base.
Determine the mounting location, and drill four mounting
holes.
Secure the unit in place, using four large self-tapping Phillips
head screws.
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
3
INSTALLATION
Self-tapping Phillips head screw
(large)
Never mount the unit near the fuel tank.
The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must
correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration
compensation will not be effective and vibration may cause the disc to skip.
position "H"
position "V"
position "45°"
Bracket
Bracket
Bracket
Hex head bolt
with washer base
NOTE: Make sure anti-vibration springs
are set to position "H".
Set the anti-vibration springs to
position "H".
Set the anti-vibration springs to
position "V".
Set the anti-vibration springs to
position "45°".
H
45°
V
H
45°
V
H
45°
V
45°
H
45°
V
NOTE:If mounting surface is carpeted, use caution
when drilling holes to prevent drill bit from
catching on carpet. Cut holes in carpet
before drilling into sub-surface.
HORIZONTAL INSTALLATION VERTICAL INSTALLAITON 45° ANGLE INSTALLATION