Filter
Top Products
Hex head bolt
with washer base
Bracket
Bracket
4
2
Attach a mounting bracket to each side of the unit, using the
hex head bolts with washer base.
Mount the unit in place, using four large self-tapping Phillips
head screws.
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Set the anti-vibration springs to position "V".
Determine the mounting location, and drill four mounting
holes.
3
4
PROCEDURE FOR VERTICAL INSTALLATION
Note
If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2.
1
Never mount the unit near the fuel tank.
Drill holes 1/8" (4mm) in diameter
position "V"
Self-tapping
Phillips head screw
(large)
Bracket
Bracket
H
45°
V
NOTE:If mounting surface is carpeted, use caution
when drilling holes to prevent drill bit from
catching on carpet. Cut holes in carpet
before drilling into sub-surface.