Filter
Top Products
AV1410
14
TUNER OPERATION
Tuner TFT Display
1. Current Radio Band Indicator
2. Radio Frequency Indicator
3. Clock
4. Stereo Broadcasting Indicator
5. Strong Local Signal Broadcasting Indicator
6. Preset Radio Stations
7. Front Zone Playing Mode
8. Rear Zone Playing Mode
9. User Defined Equalizer Level
10. Loud Setting Indicator
11. Current Preset Station Indicator
Tuner LCD Display
1. Current Radio Band Indicator
2. Radio Frequency Indicator
3. Current Preset Station Indicator
4. Stereo Broadcasting Indicator
5. Strong Local Signal Broadcasting Indicator
Switch to Radio Tuner source
Press the SRC button (15) on the front panel or remote
control (8) to switch to the RADIO TUNER source. The Tuner
TFT or LCD display appears.
Select FM/AM Band
Press the BAND button (14) on the front panel or the remote
control (20) to change between the following bands: FM1,
FM2, FM3, AM1, and AM2.
Auto Tuning
Press and hold the button (19) on remote control or the
button on the joystick (17) to seek the next available radio
station by increasing the tuning frequency. Press the button
again to stop searching.
Press and hold the button (17) on the remote control or
the button on the joystick (16) to seek the next available
radio station by decreasing the tuning frequency. Press the
button again to stop searching.
Seek Tuning
Press the button (19) on remote control or the button on
the joystick (17) to seek the next station higher.
Press the button (17) on the remote control or the
button on the joystick (16) to seek the next station lower.
Manual Tuning
Press the or buttons (14, 22) on the remote control or
the or buttons (18, 19) on the joystick to increase or
decrease the tuning frequency one step.
Using Preset Stations
Six numbered preset buttons store and recall stations for
each band. All six stored stations (P1-P6) for the current
band appear on the TFT screen.
Storing a Station
1. Select a band (if needed), then select a station.
2. Hold a preset button (8-13) for three seconds. The
preset number appears in the LCD panel.
Recalling a Station
1. Select a band (if needed).
2. Press a preset button (8-13) to select the corresponding
stored station.
Auto Store (AS)
Automatic Storing of Preset Stations
To select six strong stations and store them in the current
band:
1. Select a band (if needed).
2. Press AS (26) for > 2 seconds to activate the Auto Store
function.
The new stations replace stations already stored in that band.
Using Preset Scan
To scan stored stations in the current band:
1. Select a band (if needed).
2. Press AS (26) for < 2 seconds. The unit pauses for 10
seconds at each preset station.
3. Press AS again to stop scanning when the desired
station is reached.
Local Radio Station Seeking (LOC)
When the Local function is on, only radio stations with a
strong radio signal are played. To activate the Local function,
press and hold the LO/DX button (6) on the front panel. Press
LO/DX again to turn Local off. When the Local function is
active, the “LOC” indicator appears lit on the LCD or TFT
screen.
ST
Loc
P1
4 1
1010
11 2
5
7
8 9
3
6
1
2
3
4
5