Filter
Top Products
E. Installation
1. Installing the system onto the seat back in a car
(Refer
to Figure 7)
Figure 7
1). Unfasten the rear Velcro straps of the bag. Fold inwards the
rear piece of the bag and attach its end velcro strap to the
middle Velcro strap on the back of the bag to form a triangle.
2). Hang the bag onto the seat back by looping the shoulder strap
of the bag around the headrest of the seat.
3). Take one of the supplied straps from the lower compartment
of the bag, and connect the latch to the lower metal ring on the
left side of the bag. Attach the "S" hook to the same ring after
looping the strap around the driver's seat rail. Repeat this pro-
cess for the right side. In some vehicles, it may be necessary
to attach the "S" connector to the rail directly, as it may not be
long enough to reach back to the ring.
4). Adjust the straps tightly so that the bag is secured.
5). Unzip the bag and flip down the front flap. Ensure the inside
Velcro straps of the bag is fastened to prevent the unit from
falling. Swing the monitor upwards and adjust the screen for
the desired viewing angle.
88
88
8