Filter
Top Products
-9-
128-6116
9 of 16
Remote Controlled VCP Functions
These features can only be used with an Audiovox Video
Cassette Player, if this option was installed with your
video package.
17. POWER BUTTON
This button is used to turn the VCP on and off.
18. “REW” REWIND BUTTON
If this button is pushed while the tape is stopped, the
tape will rewind. If this button is pushed while the
tape is playing, the VCP will go into rewind search
mode. For more information consult the Audiovox
VCP owner’s manual.
19. PLAY BUTTON
Press this button to activate play mode while a tape
is loaded into the VCP. This button may also be
used to disengage search and pause modes. For
more information, consult the VCP owner’s manual.
20. “F.FWD.” FAST FORWARD BUTTON
If this button is pushed while the tape is stopped,
tape will fast forward. If this button is pushed while
the tape is playing, the VCP will go into fast forward
search mode. For more information on the search
feature of the VCP, consult the VCP owner’s manual.
21. REPLAY BUTTON
Pressing this button will rewind tape and immediately
begin playback when the tape is fully rewound.
22. STOP BUTTON
Press this button to stop the tape.
CHANNEL SET UP
In order to easily access all available TV channels, it
may be necessary to perform channel auto-
programming whenever the vehicle’s geographic
location has changed, i.e. city to city, weak signal area.
1. Press the AUTO MEMORY button on the Remote
Control Unit or the AUTO PROGRAM button on
the drop down video unit. You will see the TV
cycle through all its channels. The built-in
microprocessor will automatically note each
channel that is actively broadcasting in your area.
2. (A) To tune only strong clear channels with
the CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE ON” is displayed on
the bottom of the screen. The TV will now
tune only to strong active channels when the
UP or DOWN buttons are used on the monitor
or remote control.
3. (B) To tune weak or marginal channels with
the CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE OFF” is displayed on
the bottom of the screen. Tune to the desired
channel using the CHANNEL UP/DOWN
buttons or go directly to the channel by using
the 0-9 buttons on the Remote Control.