Filter
Top Products
ACM 5450
20
Each time the radio is switched on, stereo
playback is activated ( is displayed).
The unit will automatically switch to mono if
the received signal is not strong enough for
stereo playback.
Changing the memory bank
You can shift between the memory banks I, II
and T in order to store stations and recall
them later.
The currently selected memory bank is indi-
cated in the display.
• Toggle the FM button until the desired
memory bank lights up in the display.
Storing stations
On FM, you can store five stations on the
preset buttons 1 to 5 for each of the memory
banks I, II and T.
• Select the memory bank with FM.
• Tune in a station either automatically or
manually.
• Press the desired preset button until
the radio resumes play after the muting
and you hear the beep.
Now the station has been stored.
The activated preset button is indicated in the
display.
If you leave the service area of the regional
programme tuned into, or if you would like to
take advantage of the full RDS service,
switch to “REG OFF”.
• Press the AF button for approximately
2 seconds until “REG OFF” appears.
When active, “REG ON” will be briefly dis-
played each time the radio is switched on.
Selecting a station
With this car radio you can receive FM stati-
ons from 87.5 to 108 MHz.
Using the
buttons there are two different
ways to tune into a station:
Automatic tuning
Prerequisite: “AF” and “m” do not light up in
the display, i.e. the Alternative Frequency
function and manual tuning are switched off.
Use the AF and lo buttons (lo, m, -, lo) to
adjust the respective modes.
• Press
; the car radio will automati-
cally search for the next station.
When keeping the or the button depres-
sed, seek tuning will speed up in upwards or
downwards direction.
Manual tuning
Prerequisite: “m” lights up in the display.
Toggle the lo button until “m” is displayed.
• Press
; the frequency will change in
short intervals in upwards or down-
wards direction.
When holding the
or button down, the
frequency scan is speeded up.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
For this,
• press the lo button briefly.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also pick
up weaker, distant stations (high sensitivity).
Make sure that “m” is not indicated in the
display.
Switching from stereo to mono
(FM)
If reception is poor, you may get better sound
quality by switching to mono:
• Press the lo button until a beep sound
is released and the stereo sign
dis-
appears from the display.