Filter
Top Products
E-10
ENGLISH
FRANÇAIS
ESPAÑOL
PORTUGUÊS
The distance to the fire wall varies
due to the type of the car. Be sure to
secure the unit by properly inserting
the bushing.
*Caution
Insufficient fastening of the screw or
mounting strap may cause some
CD’s to skip.
Fire wall
Reset button
Press the reset button with the point of a
sharp object such as a ball-point pen.
POWER SELECT SWITCH
(Located on the bottom of the unit)
Change the position with a jeweler’s screwdriver, etc.
A : Your car has an accessory position on the ignition
switch.
B : Your car has no accessory position on the ignition
switch.
Be sure to
press the reset button after changing the
switch and connecting the lines.
Supplied Mounting Hardware
Sleeve
Bushing, Locking Mounting Strap Release
Screw screw and Screw Keys
Precautions
• Be sure to detach the front panel before you start in-
stalling the unit.
• Choose the mounting location carefully so that the unit will
not interfere with the normal driving operations of the driver.
• Use only the supplied mounting hardware for a safe and
secure installation.
• When mounting the unit in a car, keep the unit as level as
possible. If the unit must be mounted at an angle, due to the
design of the vehicle, make sure that the unit does not tilt
upward by more than 30°.
Mounting Example
Installation in the dashboard.
1. Install the sleeve in the dashboard.
2. Select and bend the appropriate tabs to hold the sleeve
firmly in place.
Mounting Strap Use*
3. Attaching the Mounting Strap to the underside of the dash
board, using screw.
Attach the back of the unit to the Mounting Strap using
the support stem bolt and hardware.
Bushing Use
3. As shown in the figure below, securely fasten the screw,
which has been inserted into the bushing to the rear of
the set.
If your car has no accessory position on the
ignition key switch (POWER SELECT switch)
The illumination on the front panel is factory-set to be turned
on even when the unit is not being played. However, this set-
ting may cause some car battery wear if your car has no ac-
cessory position on the ignition key switch. To avoid this bat-
tery wear, set the POWER SELECT switch located on the
bottom of the unit to the B position, then press the RESET
button. The illumination is reset to stay off while the unit is not
being played.
Installations
AUSTIN CD41 01.3.22, 1:45 PM10