Filter
Top Products
36
LOUDNESS Loudness boosts the bass
frequencies at low volume.
LOUD 1 - Low boost
LOUD 6 - Max. boost
BAS CENT Bass Center Frequency Ad-
justment.
Adjusts the mid-range fre-
quency to the specific
equipment in the vehicle
(50 or 100 Hz)
TA VOL The traffic announcement
and warning beep volume
can be set between 0 to 63.
The message will then
come through at this volu-
me, if the standard volume
is lower.If the standard vo-
lume is set higher than the
TA VOL level, then the traf-
fic report will be played at
the standard volume.
REG OFF To listen to a regional radio
programme outside of its
RDS transmission range,
switch on "REG ON".
For full RDS service, switch
to "REG OFF".
Naming an external audio
source
AUX NAME makes it possible to enter a
name of up to 8 characters for an external
audio source (AUX ON, see DSC Menu).
For this, press SRC to select the AUX mode
(only possible if AUX ON is set in the DSC
menu).
• Press SRC as often as required until
AUX appears in the display.
Enter the AUX NAME in the DSC menu.
• Press DSC briefly.
• Press
/ to select the AUX NAME
function
• Press << >> to enter into editing mode.
The adjustable position will flash.
• Press / to select a character you
want to enter. Select a dash “_” to leave
a blank space.
• Press << >> to select the next position.
• When you have entered the name com-
pletely, press DSC briefly to store the
name.
• Press DSC again to quit the DSC menu.
DSC programming
The car radio has been equipped with DSC
(Direct Software Control) to allow you to cu-
stomise certain programmable, basic set-
tings to suit your personal needs and pre-
ferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always re-
set to them if desired.
If you wish to alter any of the programming,
• press DSC.
MENU
/ will light up in the display.
Use the
/ buttons on the rocker switch
to select the functions you wish to change.
The display will show you the setting you
have selected. Press << >> on the rocker
switch to change the values. Confirm the
setting you have selected by pressing the
DSC button.
/ Select function
<< >> Adjust/recall value
Cob/Portof/Colo gb® 30.05.2002, 10:16 Uhr36