Blaupunkt PCA 250 Car Amplifier User Manual


 
LINE LEVEL INPUTS - The most commonly used inputs in the aftermarket world are RCA type line level inputs. These inputs
can handle up to about 6 Volts rms without overdriving the amplifier. Such high voltages are rarely found from car audio
head units so this is a very comfortable value. But, should the use need to drive the amp directly from speaker level leads,
use the supplied “High Level Adapter” to connect to the amp.
POWER ON LED - This light will turn on when the amplifier receives a +12V turn on signal from the radio. If the amp is properly
wired, but the light does not turn on, there may be a short circuit condition that the amp is protecting itself from.
PROTECTION LED - This light turns on if the amplifier senses a severe problem, such as a speaker short circuit.
BASS BOOST - This control provides additional bass in the 45Hz area to give a stronger low end “feel” to the bass. Once
switched on, this will also allow the amp to be driven into distortion sooner so the user must be aware.
GAIN CONTROL - The gain control allows for a range of 0.3-6Volts input. This means that if the setting is a 0.3V, it only takes
0.3Volts to drive the amp to full output. (Such a low setting allows for the amp to be easily overdriven and more
susceptible to noise so a mid-position is highly recommended for most radios.)
LOW-PASS FREQUENCY - If the mode selector is in the “LP” position the amplifier passes only low frequency sound. The
upper limit for such sound is set via this control. For bass, a value just below 100Hz is usually best.
HIGH-PASS FREQUENCY - If the mode selector is in the “HP” position the amplifier passes only mid and high frequency
sound. The lower limit for such sound is set via this control. A common setting is just above 100Hz.
CROSSOVER MODE - Depending upon the system design chosen, you need to set the amplifier in the proper “mode” be it LP,
Flat, or HP. The low-pass and high-pass frequency settings are explained above. The “Flat” setting simply allows for the
amp to pass all audio frequencies without any kind of crossover filter application. (This is common with 6x9” fullrange
coaxial speakers for example.)
CONNECTIONS & CONTROLS
7
Line Level Input
Bass Boost
High-Pass
Frequency
Low-Pass
Frequency
Crossover
Mode
Protection
LED
Gain Control
Power On
LED