Blaupunkt RCM 104 Car Stereo System User Manual


 
27
Paris RCM 104
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Manual seek tuning << >>
(prerequisite: AF is switched off!)
Press << or >> to change the frequen-
cy in small steps in upwards/down-
wards direction.
Hold down the right or left part of the rocker
switch to speed up this procedure.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
If “lo” is indicated, the radio will only pick up
strong stations (low sensitivity).
If “lo” is deactivated, the radio will also pick
up less powerful stations (higher sensitivity).
The degree of sensitivity can be separately
adjusted for both levels (see chapter “DSC
programming”).
Stereo - mono switch (FM)
You can switch to mono when the reception
quality becomes poor:
Press lo for approximately 2 seconds.
During mono reception the stereo symbol
in the display will go out.
Each time the car radio is switched on, the
radio will be automatically set to stereo re-
ception.
Selecting the waveband
With your car radio you can select between
the following wavebands:
FM 87.5 – 108 MHz
MW 531 – 1602 kHz, and
LW 153 – 279 kHz
Select the desired waveband by pres-
sing the FM
T or M•L button.
To switch between MW and LW:
press M•L.
Automatic seek tuning /
Press / . The radio will automatically
tune into the following station.
If you keep the upper or lower part of the
rocker switch
/ depressed, seek tuning
speeds up in upwards or downwards direc-
tion.
down in short
intervals
up in short
intervals
down
up
It will automatically switch to mono when the
reception quality becomes poor.
Changing the memory bank (FM)
You can shift between the memory banks I, II,
and T to store and recall preset stations.
The selected memory bank is indicated in the
display.
Press FM
T until the desired memory
bank lights up in the display (press re-
peatedly if necessary).
Storing stations
Using the preset buttons 1, 2, 3, 4, 5, 6 you
can store six stations on each FM memory
bank (I, II, T).
In the MW/LW range you can store six stati-
ons each.
Press the FM
T or M•L button to select
the waveband.
Use the rocker switch to tune to a stati-
on (either automatically
/ or manu-
ally << >>).
Press the desired preset button and
hold it down. The radio will be muted
and will resume play after approximate-
ly 2 seconds.