Filter
Top Products
Paris RCM 104
28
Recalling stored stations
You can recall any stored station by pressing
the corresponding preset button.
• Press FM
T or M•L to select the wave-
band. For FM, also choose the corre-
sponding memory bank by pressing
FM
T until the desired bank is indicated
in the display.
• Briefly press the corresponding preset
button.
Sampling stored stations briefly
with Preset Scan
With this function you can briefly sample all
preset stations of a waveband. Choose the
desired SCANTIME in the DSC menu.
• Briefly press PS/SCA.
The radio will briefly play all the stored
stations of the tuned in waveband one
after another.
On FM, the system will sample the stations of
one of the memory banks I, II, or T, depen-
ding on which bank was selected before.
Free preset buttons will be skipped.
To switch off Preset Scan:
• Press PS/SCA once again.
The radio will continue to play the cur-
rently sampled station.
Now the station is stored. The activated pre-
set button is indicated in the display.
Note:
Should you tune into a station which has
already been stored, the corresponding pre-
set button and the memory bank will start
flashing in the display for a short while, if you
have selected another memory bank.
Storing the strongest stations
automatically with Travelstore
You can use the Travelstore memory bank to
automatically store the six strongest FM sta-
tions sorted on the preset buttons according
to their signal strength. This feature is espe-
cially useful when travelling, because it will
always give you the most powerful stations at
a fingertip as you pass through the various
reception areas.
• Press FM
T for at least 2 seconds.
The radio will seek the six most powerful FM
stations and store them on the “T” memory
bank (Travelstore). As soon as this procedu-
re has finished, the first station will be played.
FM stations can also be stored manually on
the Travelstore memory bank (see “Storing
stations”).
Sampling stations briefly with
Radio Scan
Starting with the currently played station, you
may let the system sample the following ones
one after another. Choose the desired
SCANTIME in the DSC menu.
To activate Scan:
• Press PS/SCA for about 2 seconds.
The sampled frequency or the station
name starts flashing in the display. Du-
ring the actual search process, “SCAN”
is flashing.
To continue listening to a sampled stati-
on/switch Scan off:
• Briefly press PS/SCA.
If no station is selected during the search
operation, the scan function will be automa-
tically switched off after the entire frequency
band has been passed through. The radio
will then return to the initial station that was
being played when the scan function was
activated.
For more information, please also refer to
chapter “DSC programming - SCANTIME”.