Filter
Top Products
40
If desired, stations can also be stored
manually on the Travelstore bank (see
“Storing stations”).
Recalling stored stations
You can recall any stored station by pres-
sing the corresponding preset button.
• Select the waveband using FM or TS.
• Briefly press the corresponding preset
button.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all wavebands.
To start Preset Scan:
• Press SC for approximately two secon-
ds.
All of the stored stations of the adjusted
waveband will be scanned one after the
other. The memory bank and preset posi-
tion of the currently scanned station will flash
in the display.
To select a scanned station and switch
off Preset Scan:
• Press SC briefly.
Scanning stations with
Radio-Scan
You can also scan all stations which can be
received.
To start the Scan function:
• Press SC briefly.
The scanned frequency or the station name
will start flashing in the display. During the
actual scanning process “FM-SCAN” will be
displayed.
To select a scanned station and switch
off the Radio-Scan function:
• Press SC briefly.
If no station is selected, the scan function
will be automatically switched off after the
frequency band has been run through com-
pletely. The unit will tune in the station lis-
tened to before starting the scan.
Changing the scan time
The scan time can be changed from be-
tween five to a maximum of 30 seconds.
Please refer to chapter “DSC programming
- SCANTIME”.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, distant stations (high sen-
sitivity).
The sensitivity level can be altered in both
modes (see also chapter “DSC program-
ming”).
Switching from stereo to mono
If reception is poor, you may get better
sound quality by switching to mono:
• Press the lo button for approximately
two seconds.
With mono playback, the stereo sign
will
disappear from the display.
Each time the radio is switched on, stereo
playback is activated.
The unit will automatically switch to mono if
the received signal is not strong enough for
stereo playback.
Heidelbg RCM126 gb® 07.06.2002, 12:46 Uhr40