Filter
Top Products
Frankfurt RCM 82
32
The stations must be stored on the storage
levels I-III.
For entering a station name, proceed as
follows:
● Press the DSC button 5.
The display G a gives you “BEEP ON”
or “BEEP OFF”.
● Press the rocker switch
/ J until
‘PRESET’ is illuminated on the display
G a.
● Choose the desired station (via the
preset buttons), for which the name is
to be entered.
The station frequency, e.g.
_ _ 92.1_ _
is indicated on the display G a. The remai-
ning fields are marked with “_”. When en-
tering the first character, the frequency dis-
appears and is replaced by further dashes.
The first dash is blinking. For changing it and
entering the desired character:
● Press the rocker switch << / >> I on
the right continuously.
The display will give you one after the other
the capital letters (A-Z), the umlauts, the
special characters and the numbers 0-9.
For selecting a character:
● Press the ON/OFF button 1.
The selected character stops blinking
while the next character starts to flash.
For modifying the previous character:
● Press the ON/OFF button 1 for longer
than two seconds.
Once you have finished your entry, press the
corresponding preset button of the next sta-
tion, which you would like to be named. The
entered name for the previous station is then
automatically stored.
For storing the adjustment:
● Press the DSC button 5 once again.
Every time the station is selected, the speci-
fied name will be represented on the display.
The zone identification for traffic messages
(ARI) is no longer indicated.
A memorized station name can be deleted by
storing a new station on this button (i.e.
keeping the respective preset button depres-
sed for a longer period).
Sensitivity of the Automatic
Station Seek Operation
In areas with an extremely high or very low
station densitity it might be useful to alter the
sensitivity of the automatic station seek (lo or
dx button).
For changing the sensitivity:
● Press the DSC button 5.
The display G a gives you“BEEP ON”
or “BEEP OFF”.
● Press the
/ rocker switch J until
‘LOCAL’ and a number between 1 and
3 appear on the display G a.
LOCAL stands for local reception.
● Adjust the sensitivity with the << / >>
rocker switch I:
01 corresponds to high sensitivity
03 corresponds to low sensitivity
If required, use the rocker switch
/ J to
select “DIS” (distant reception) and change
the sensitivity.
For memorizing the setting:
● Press the DSC button 5 once again.
Survey of DSC settings adjusted
ex factory
BEEP : ON
COLOUR : orange
LED : 2
LOUD : 3
PRESET : ---
LOCAL : 1
DIS : 1
ARI : 5