Filter
Top Products
23
BA Malta RCR 45 gb
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Priority of traffic announcements
ON/OFF
“TA” lights up in the display, if the priority of
traffic announcements is on. To switch the
function on and off,
• press the TA button.
Warning beep
Whenever you leave the reception area of
the traffic program station you are tuned to,
you will hear a warning beep after approxi-
mately 30 seconds.
This warning beep will also be released, if
you press a preset button to recall a preset
station without traffic program.
Switching the warning beep off
a) Tune to another traffic program station:
• Press the rocker switch 2 or
• press a preset button to recall a
traffic program station.
or
b) Switch the traffic message priority off:
• Press TA.
“TA” goes out in the display.
Automatic seek tuning start
(During cassette operation)
If you leave the reception area of your traffic
program station while you are playing a cas-
sette, the car radio will automatically tune
into another traffic program station.
If no traffic program station is found within
approximately 30 seconds, the tape will be
stopped and you will hear a warning beep.
To switch the warning beep off, proceed as
detailed above.
Adjusting the volume for traffic
messages and warning beep
A default value is set ex factory for the volu-
me of traffic announcements and the warning
beep. You can change this default setting
with the DSC function (see “DSC programm-
ing, ARI, TA”).
Reception of traffic announcements with RDS-EON
Many FM broadcasters provide their service
area with traffic messages at regular inter-
vals.
All traffic program stations transmit a special
signal parallel to the radio program. Your car
radio is able to identify such traffic program
station by this TP signal. The display will
indicate “TP” to confirm that a traffic program
station is tuned in.
Other radio stations do not air traffic announ-
cements by themselves, but offer the possi-
bility to receive the traffic announcements of
another radio station within the same radio
network. During reception of such a station
(e.g. NDR3) “TP” lights on the display as
soon as the priority of traffic announcements
is activated. Then the display has to light
“TA”.
If a traffic announcement is aired, your radio
will switch to the traffic program station for the
duration of the message and will switch back
to the previous station after the end of the
message.