Blaupunkt RCR 45 Car Stereo System User Manual


 
21
BA Malta RCR 45 gb
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Note:
If you tune into a station which has already
been stored on another memory bank, the
corresponding preset button and the memo-
ry bank will start flashing on the display for a
short while.
Storing the strongest stations
automatically with Travelstore
You can use the Travelstore memory bank to
automatically store the six strongest FM sta-
tions sorted on the preset buttons according
to their signal strength. This feature is
especially useful when travelling, because it
will always give you the most powerful stati-
ons at a fingertip as you pass through the
various reception areas.
Press TS for at least 2 seconds.
The radio will seek for the most powerful
nearby FM stations and store them on the
memory bank T (Travelstore). Once the
process is completed, the station allocated to
preset button 1 will be played.
FM stations can also be stored manually on
the Travelstore bank (see Storing stations).
Adjusting the seek tuning sensi-
tivity
Two basic levels can be selected for the seek
tuning sensitivity.
If lo is displayed, the radio will only tune to
strong stations (low sensitivity).
If dx is displayed, you will also receive less
powerful stations (higher sensitivity).
To change the seek tuning sensitivity,
press lo or dx.
The two basic sensitivity levels can be further
varied (see DSC programming).
Stereo - mono switch (FM)
You can switch to mono when the reception
quality becomes poor:
Press lo for approximately 2 seconds.
During mono reception the stereo sym-
bol
will go out in the display.
Each time the car radio is switched on, the
radio will automatically be set to stereo recep-
tion.
It will automatically shift to mono when the
reception quality becomes poor.
Changing the memory bank (FM)
You can shift between the memory banks I, II
and III to store and recall preset stations.
The selected memory bank is indicated in the
display.
Press FM until the desired memory
bank lights up in the display (press re-
peatedly if necessary).
Storing stations
On each FM memory bank (I, II, III and T) you
can store six stations on the preset buttons 1,
2, 3, 4, 5, 6.
Select the memory bank by pressing
FM or TS to adjust the waveband.
Press the FM button to select one of
the FM memory banks.
Use the rocker switch to tune to a sta-
tion (either automatically or manually).
Press the desired preset button and
hold it down. The radio will be muted
and resumes play after about 2 se-
conds.
Now the station is stored.
The activated preset button is indicated in the
display.