Filter
Top Products
17
BA Malta RCR 45 gb
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
7 1, 2, 3, 4, 5, 6 - preset buttons
You can store 6 stations on each FM
memory bank (I, II, III and T).
To store a station: Press button during
radio operation and hold it down until
the radio resumes play.
To recall a station: Select a memory
bank (press repeatedly if necessary
and then press the required preset but-
ton.
Extra function:
Coding - Read chapter “Anti-theft cod-
ing” first.
Buttons 1, 2, 3, 4 - To enter the four-
digit code.
Press each button repeatedly until the
four-digit code given in the car radio
passport is displayed.
8 PS (Preset Scan)
To briefly sample all stored stations of
the selected memory bank (FM I-III or
T).
9 lo; dx
Seek tuning sensitivity
lo lit up in the display indicates normal
seek tuning sensitivity (the system will
pick up strong stations only).
dx lit up in the display indicates high
seek tuning sensitivity (the system will
also pick up weaker stations).
To change the seek tuning sensitivi-
ty: press lo or dx.
: DSC (Direct Software Control)
Use the DSC function to change a
number of basic settings. See “DSC
programming” for more details.
; AF - Alternative Frequency in RDS
mode
If “AF” is on, the radio will automatically
switch to the strongest frequency of the
same program.
AF on/off: press AF briefly.
< TA (Traffic Announcement)
If “TA” is on, only traffic announce-
ments will be received.
TA on/off: press TA.
= TS (Travelstore)
To store the six most powerful nearby
stations automatically with Travelstore.
Store: Press TS until seek tuning starts
(see display).
Recall: Press TS until “T” appears in
the display. Then briefly press one of
the presets 1, 2, 3, 4, 5, 6.
> FM - FM
To select one of the FM memory banks
I, II or III.
To change the memory bank:
Press button until the desired memory
bank is indicated in the display.
? TRE - Treble
BAS - Bass
BAL - Balance (left/right)
FAD - Fader (front/rear)
To select, press TRE, BAS, BAL or
FAD.
The set value is shown in the display
(e.g. TRE +5).
Then use the rocker switch 2 to chan-
ge the value. Press any other button to
store the new value.
If the value is not changed within 8 se-
conds, the display will show the pre-
vious setting again.