Filter
Top Products
29
Verona RCR 45
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
DSC programming
DSC (Direct Software Control) allows you to
customise certain programmable, basic set-
tings to suit your personal needs and prefe-
rences and then store them.
The basic settings for this audio equipment
were made at the factory. In the following you
can find an overview of these settings, so that
you can always reset to these if desired.
If you wish to alter any of the programming,
• press DSC.
The display will show you the adjusted con-
dition.
Use the rocker switch to select and adjust the
functions described in the following.
/ Select function
Adjust value –
Adjust value +
TA VOL To adjust the traffic an-
nouncement volume from
between 1 to 9. The mes-
sage will then come
through at this volume.
(1 = low)
BEEP Confirmation tone for all
functions which require a
button to be pressed for
more than 2 seconds.
The volume can be adju-
sted from between 0 to 9.
(0 = off)
Each alteration of this va-
lue is confirmed by a beep
tone of the corresponding
volume.
LED (code) You can adjust the LED B
to flash for extra anti-theft
protection.
LED 1 - LED always flash-
es when the unit
has been swit-
ched off via the
ignition.
LED 0 - No flashing.
LOUD Loudness - When listening
at a low level, the Loud-
ness function creates a
more natural sound by
boosting the low frequency
range.
LOUD 1- Low boost
LOUD 6- Max. boost
PROG selector
(To change the tape direction during
cassette playback)
• Press FR and FF simultaneously.
At the end of a tape side, the mechanism
changes directions automatically to play the
other side (Autoreverse). The display shows
“TR1-PLAY” for track (side) 1 or A or “TR2-
PLAY” for track 2 or B.
Notice:
If there is too much tension on the tape during
playback, the set may switch over by itself
before having reached the end of the tape
side. In this case check the condition of the
cassette tape. Sometimes it helps to rewind
it completely.