Filter
Top Products
23
Kiel RD 104
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Selecting a station
This set allows you to receive FM stations
between 87.5 and 108 MHz.
Automatic seek tuning
/
• Press / . The radio will automatically
tune into the following station.
If you keep the upper or lower part of the
rocker switch
/ depressed, seek tuning
speeds up in upwards or downwards direc-
tion.
up
down in short
intervals
(when AF is off)
down
up in short
intervals
(when AF is off)
Manual seek tuning << / >>
(prerequisite: AF is switched off!)
• Press << or >> to change the frequency
in small steps in upwards/downwards
direction.
Hold down the right or left part of the rocker
switch to speed up this procedure.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
For this:
• Press lo briefly.
If “lo” is indicated, the radio will only pick up
strong stations (low sensitivity).
If “lo” is not indicated, the radio will also pick
up less powerful stations (higher sensitivity).
The degree of sensitivity can be separately
adjusted for both levels (see chapter “DSC
programming”).
Stereo - mono switch (FM)
You can switch to mono when the reception
quality becomes poor:
• Press lo for approximately 2 seconds.
During mono reception the stereo sym-
bol
in the display will go out.
Each time the car radio is switched on, the
radio will be automatically set to stereo
reception.
It will automatically switch to mono when the
reception quality becomes poor.
Changing the memory bank (FM)
You can shift between the memory banks I
and II to store and recall preset stations.
The selected memory bank is indicated in the
display.
• Press FM until the desired memory
bank lights up in the display
(press repeatedly if necessary).
Storing stations
Using the preset buttons 1, 2, 3, 4, 5, 6 you
can store six stations on each FM memory
bank (I, II, T).
• Select FM or TS and with FM also the
desired memory bank.
• Use the rocker switch to tune to a stati-
on (either automatically
/ or ma-
nually << / >> ).
• Press the desired preset button and
hold it down. The radio will be muted
and resumes play after approximately 2
seconds. The system will also send out
a beep tone.
Now the station is stored.
The activated preset button is indicated in
the display.