Filter
Top Products
42
Selecting a waveband
The following wavebands are available:
UKW (FM) 87,5 - 108 MHz,
MW 531 - 1602 kHz and
LW 153 - 279 kHz
Press the “BA/TS” button to select the desi-
red waveband.
Station tuning
Automatic seek tuning /
• Press / ; the car radio will automati-
cally search for the next station.
If you hold
/ pressed up or down on the
rocker switch, seek tuning will speed up in
the corresponding direction.
Automatic seek tuning
Up
Down
<</>> Up/down in short intervals
(on FM only if “AF” is switched off)
Manual tuning with << >>
You can also tune into a station manually.
Important: AF and PTY must be switched
off (i.e. the symbols do not light up in the
display).
If necessary, deactivate these function by
pressing “AF.TA” or “PTY”.
Manual tuning:
• Press << >>; the frequency will change
in short intervals in the corresponding
direction.
If you hold << >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Scrolling through the broadcast
networks (FM only)
You can use the << >> buttons to tune into
stations in your reception area.
If it is possible to receive several program-
mes in the same broadcast network, you can
scroll through them in the forwards direc-
tion by pressing >>, or backwards using the
<< button, e.g. NDR 1, 2, 3, 4, N-JOY, ...
For this to work properly you must have al-
ready tuned into the stations at least once
and “AF” must be active (lights up in the dis-
play).
To do this, you can start the Travelstore seek
operation:
• Press “BA/TS” for 2 seconds; the sy-
stem will start to run through the fre-
quency band.
If “AF” is not lit up,
• Press “AF.TA” until you hear a beep.
It is now possible to select stations using
<< >>.
Switching between the memory
banks (FM)
You can switch between the memory banks
I, II and T in order to store stations and re-
call them later.
The currently selected memory bank will
appear in the display.
• Press the “BA/TS” button as many
times as necessary until the desired
memory bank lights up in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1 - 6 for each of the memory
banks (I, II, T).
On MW/LW, you can also store six stations
each.
• Select the appropriate waveband by
pressing BA/TS.