Filter
Top Products
IMPORTANT SAFEGUARDS
About this manual
01
4
Before You Start
Additional Information
11
45
This unit features a number of sophisti-
cated functions ensuring superior
operation. All the functions have been
designed for the easiest possible use,
but many are not self-explanatory. This
manual will help you understand the
functions and operations of the unit.
DISC/VCD/CD/MP3/MP4/SD operation
that can only be operated by the remote
control, but there are also functions that
can be operated by the buttons provided
for the main unit.
Be sure to connect the color coded wires
according to the diagram. Incorrect con-
nections may cause the unit to malfunct-
,
ion or damage the vehicle s electrical sy-
stem.
1
Be sure to connect the speaker (-) wires
to the speaker (-) terminal. Never conn-
ect the left and right channel speaker c-
ables each other or to the vehicle body.
2
Make sure all the connections are comp-
letely correct before turning on your unit.
3
When replacing the fuse(s), the replace-
ment must be of the same amperage as
shown on the fuse holder.
4
Do not block vents or radiator panels.
Blocking them will cause heat to build up
inside and may result in fire.
5
To lessen the driver's distraction, install
the unit in an appropriate place.
6
Power the unit on after starting the engine
otherwise it will shut off due to lack of
power.
7
Do not place the remote control in a place
susceptible to high temperature or direct
sunlight. Doing so will damage the remote.
8
Do not use the unit in
extremely high or
low temperatures. Also avoid high humidity
and direct sunlight.
9
Take care of the magnetism of the unit.
Do no put the credit card, cassette or w-
atch around the unit.
10
To minimize disturbance of the video
frequency, keep far away from the unit
when using your phone.
11
Common Symptoms
Cause Solution
There is no power.
The car ignition is
switched off
If the power supply is properly connected to
the car accessory, switch the ignition key to
ON or ACC.
The fuse has blown.
Replace with same amperatge fuse rate.
The disc cannot
be loaded.
There is another disc inside
the player
Remove the disc from the player
The device does not
work correctly
(EJECT, LOAD,
PLAY)
Inserted disc is upside down
Insert the compact disc with the label facing
upward
The surface of disc is extre-
mely dirty, Scrached or
damaged.
Clean the disc or try another disc,if the new
disc works correctly, the first disc is damaged.
Temperature inside the car is
too high.
Cool off until the ambient temperature returns
to normal.
There is no sound.
The volume control is set too
low.
Turn up the volume properly.
The device has not been wired
correctly.
Check the connections according to
the wiring diagram.
The operation keys
do not work
1. The built-in microprocessor
is not operating properly.
2. Front panel is not properly
attached into its place
1. Switch the device off and on again or press
the RESET button.
2. Remove and reinstall the front panel.
The sound of the
disc player skips
The installation angle is more
than30 degrees
The surface of the road is
uneven.
The surface of disc is extremely
dirty,scrached or damaged.
Adjust the installation angle to less than 30
degrees
Wait until the road becomes smoother before
playing the disc.
Clean the disc or try another disc, if the new
disc works correctly, the first disc is damaged.
No radio reception.
The antenna cable is not
connected.
Insert the antenna cable firmly into the antenna
socket of the unit.
In automatic search
mode the radio does
not stop at a trans-
mitting station.
The transmission signals are
too weak.
Tune in to a radio station manually.