Filter
Top Products
Page 6 of 16 SC-1002 / 1012 / 1022-10 14 Installation Instructions
2/20/08 CP4997B
MOUNTING (Main unit)
The mounting bracket supplied can be installed above
or below the unit. Mounting bolts slide into channels
on each side of the case. Lockwashers should be
used between the case and bracket as well as be-
tween the bracket and nut. Choose a mounting loca-
tion convenient to the operator and away from any air
bag deployment areas. Inspect behind mounting area
for clearance. Assure adequate ventilation to prevent
overheating. Consider wire routing and access to
connections. Install mounting bracket to vehicle using
1/4" hardware (not supplied).
SC-1012 Remote Panel: The remote panel of the SC-1012 is typically mounted underneath the
vehicle dashboard using mounting hardware (not supplied). Mount the panel in a location away
from the driver’s or passenger’s legs.
SC-1022 Hand Control: Choose a mounting location convenient to the operator and away from
any air bag deployment areas. Consider cable routing to amplifier. Mount the hand control with
supplied Hook and Loop tape (VELCRO). If the tape method is not preferred, the hand control
may be mounted several ways. A Holster (CP5003) to hold the Hand Control or a Hanger and
Holder to hold the Hand Control like a microphone (ED1865) are available accessories.
See PARTS and ACCESSORIES Section.
Lockwashers
Nut
Channel
(from rear)
Bolt
Bracket