Filter
Top Products
280-7282-00
3 4
English
The control panel can be detached to prevent
theft. When detaching the control panel, store it
in the included DCP case to prevent scratches.
We recommend taking the control panel with you
when leaving the car.
Removing the DCP
1. Turn off the power.
2. Press the DCP Release button .
*
The DCP is unlocked.
3. Remove the DCP.
Attaching the DCP
Insert the DCP into the right side of the source
unit and press the left side to lock it.
Do not insert the DCP from the left side. Doing so
may damage it.
Storing the DCP in the DCP Case
Hold the DCP, in the orientation as shown in the
figure below, and put it into the supplied DCP
case. (Ensure the DCP is in the correct orienta-
tion.)
• The DCP can easily be damaged by shocks. After
removing it, place it in its case and be careful not
to drop it or subject it to strong shocks.
•
When the release button is pressed and the DCP
is unlocked, the car’s vibrations may cause it to
fall. To prevent damage to the DCP, always store it
in its case after detaching it.
•
The connector connecting the source unit and the
DCP is an extremely important part. Be careful not
to damage it by pressing on it with fingernails,
pens, screwdrivers, etc.
Note:
•
If the DCP is dirty, wipe off with a soft, dry cloth.
DCP Rear Panel Source Unit Front
Source unit connector
DCP
connector
1
2.
CONTROLS / COMMANDES / CONTROLES
CAUTION
1 2 3 4 5 6
SOURCE UNIT / APPAREIL PILOTE / UNIDAD FUENTE
DISPLAY
AFFICHEUR
VISUALIZADOR
Cassette Insertion Slot
Fente d’insertion de la cassette
Ranura de inserción de casete
1
*(
3
6
)
2
&
4
0
¥
@#$% 9 8
!
7
5
English
Français
Español
1. Tape slack can lead to operating difficulties.
Remove tape slack before inserting a cas-
sette, particularly when using C-90 or prere-
corded cassettes.
2. Use C-30 to C-90 cassettes. Avoid use of
C-120 or longer cassettes (The very thin tape
may stretch or break).
3. Clean the head periodically with a good com-
mercial head cleaner. Avoid touching the
head with magnetic or hard objects.
4. Do not oil the cassette mechanism.
5. Always remove the cassette from the mecha-
nism when not in use. Exposure to direct sun-
light, extreme temperatures or high humidity
may damage cassettes.
6. The cassette tape will automatically eject
from the mechanism if it is damaged. Always
ensure that cassette tapes are in good condi-
tion prior to use.
3.
CASSETTE PRECAUTIONS AND CARE
4. DCP (Detachable Control Panel)
Note:
Be sure to unfold this page and refer to the front diagrams as you read each chapter.
Remarque:
Veuillez déployer cette page et vous référer aux schémas quand vous lisez chaque chapitre.
Nota:
Cuando lea los capítulos, despliegue esta página y consulte los diagramas.
CAUTION
45
Español
Sintonizador FM
Margen de frecuencias
……87,9 MHz a 107,9 MHz
Sensibilidad utilizable……11 dBf
Sensibilidad de silenciamiento 50 dB
……17 dBf
Selectividad de canal alterno……75 dB
Separación estereofónica (1 kHz)……35 dB
Respuesta en frecuencia (±3 dB)
……30 Hz a 15 kHz
Sintonizador AM
Margen de frecuencias
……530 kHz a 1.710 kHz
Sensibilidad utilizable……25
µ
V
Cassette
Lloro y trémolo (WRMS)……0,06%
Separación de canales (1 kHz)……45 dB
Relación señal/ruido
……70
µ
s (CrO
2
, FeCr, Metal):
58 dB
Respuesta en frecuencia (± 3 dB)
120
µ
s (normal)……30 Hz a 18 kHz
70
µ
s ((CrO
2
, FeCr, Metal)……30 Hz a 20 kHz
Amplificador de Potencia
Potencia máxima……140 W (35 W × 4 canales)
Potencia media continua
……14 W × 4, en 4 Ω, 20 Hz a 20 kHz, 1%
THD
Preamplificador
Acción de control de bajos (30 Hz)……±15 dB
Acción de control de agudos (10 kHz)
……±10 dB
Salida de línea (con CA, 1 kHz, 10 KΩ)…0,7 V
General
Tensión de alimentación
……14,4 V CC (10,8 a 15,6 V permisible)
Consumo……Menos de 10 A
Impedancia del altavoz
……4 Ω (4 Ω a 8 Ω permisible)
Peso……3,52 lb. (1,6 kg)
Dimensiones
……7
"
(178 mm) Ancho ×2
"
(50 mm) Alto ×
6-3/32
"
(155 mm) Profundo
Notas:
•
Las especificaciones se adecúan a las normas EIA.
•
Con el propósito de introducir mejoras, las especifi-
caciones y el diseño del producto están sujetos a
cambios sin previo aviso.
2
"
(50 mm)
2-1/4
"
(58 mm)
7
"
(178 mm)
7-3/8
"
(188 mm)
6-3/32
"
(155 mm)
3/4
"
(19 mm)
9. ESPECIFICACIONES
ARX4570 Cover+P45 99.3.4 1:10 PM Page 3