Filter
Top Products
58 VRX925VD
English
Owner’s manual
●PL II Control
∗ This function is available only when the MUSIC
MODE is selected for Dolby PL II . For setup
details, see “Selecting the Dolby PL II (Dolby
Pro Logic II) type.”
3-1. Touch the [PL II CONTROL] key to show
the submenu.
3-2. Touch the [PANORAMA], [DIMENSION] or
[CENTER WIDTH] key to select respective
item.
[PANORAMA]:
Touch the [ON] or [OFF] key. “OFF” is the
default value.
[DIMENSION]:
Touch the [w] or [z] key to make
adjustments between 0 and 6. The default
value is “3”.
[CENTER WIDTH]:
Touch the [w] or [z] key to make
adjustments between 0 and 7. The default
value is “3”.
●Filter
This function is used to select filter frequencies
that suit the speakers that are used.
∗ This function is not available for speakers whose
SPEAKER SEL setting is set to OFF.
3-1. Touch the [FILTER] key to show the
submenu.
3-2. Touch the [FRONT HPF], [CENTER HPF],
[SURROUND HPF] or [SUB WOOFER
LPF] key to set respective item.
3-3. Touch [w] or [z] key to make settings.
[FRONT HPF]:
This function can be set to the following
four settings: 50 Hz, 80 Hz, 120 Hz or
THROUGH. “THROUGH” is the default
value.
[CENTER HPF]:
This function can be set to the following
three settings: 50 Hz, 80 Hz and 120 Hz.
“120 Hz” is the default value.
[SURROUND HPF]:
This function can be set to the following
four settings: 50 Hz, 80 Hz, 120 Hz or
THROUGH. “THROUGH” is the default
value.
[SUB WOOFER LPF]:
This function can be set to the following
three settings: 50 Hz, 80 Hz and 120 Hz.
“120 Hz” is the default value.
Multiple Channel Processor Operations
MCP control function
This function is available when a Multiple
Channel Processor (DVH920) is connected.
When the Multiple Channel Processor (DVH920,
sold separately) is CeNET connected, the
Multiple Channel Controller (DVC920, sold
separately) cannot be used.
This section describes operation procedures only.
For other details, refer to the owner’s manual
supplied with the Multiple Channel Processor.
∗ For details on functions of each mode, refer to the
owner’s manual supplied with the DVH920.
1. Press the [ADJ] button to show the ADJUST
MODE menu.
2. Touch the [SOUND] key.
SOUND
3. Touch the required keys to make the desired
setting.
●SPEAKER SEL (speaker sel)
This function determines center speaker,
surround speaker and sub woofer connection.
3-1 Touch the [SPEAKER SEL] key to show the
submenu.
3-2 Touch the [CENTER SP], [SURROUND SP]
or [SUB WOOFER] key and the “ON” or
“OFF” key to turn speakers on or off
depending on what speakers are connected.
• The default value is “ON”.
• The phase of the “SUB WOOFER” is
reversed in the ON- setting. The default
value is “ON+”.