Filter
Top Products
Commercial Audio Series Business Music System
page 17
Operation Manual
3 Operation
XM124
XM124
Artist Song title
Artist Song title
Preset Category name
Preset Category name
Channel Name
Channel Name
XM124
XM124
Artist Song title
Artist Song title
Category Category name
Category Category name
Channel Name
Channel Name
OPERATION BY REMOTE CONTROL
To listen to a channel by direct entry
1. Press the Direct Entry button on the remote control.
2. Using the Digits 0-9, select the 1-, 2-, or 3- digit channel number you
would like to access.
3. Press OK.
To listen to a channel by scrolling through channels
1.Press CH + to go to higher channels.
2.Press CH – to go to lower channels.
3.Press OK to confi rm your channel selection.
To set up Preset channels
1. Using direct entry or CH +/–, fi nd the channel you would like to set as a
preset, and press OK.
2. For presets 0-9, hold the desired preset digit for 2 seconds. For presets
10-16, press 1, then hold the second digit (0 through 6) of the preset for 2
seconds.
3. Repeat Steps 1-2 for the remaining Presets.
To listen to a Preset channel by direct entry
1. For presets 0-9, press the desired preset digit you would like to recall.
2. For presets 10-16, press 1, then the desired preset digit you would like
to recall.
3. The station will change.
To listen to a Preset channel by pressing Preset +/–
1. Press PSET + or PSET– to go through presets 1 through 16.
2. Press OK to listen to preset desired
To select channels by categories (musical genres)
“Category” means the type of programming offered on a channel, such as
rock, country, jazz, news, etc.
1. Press Category < or > on the remote to select the next or prior
cate gory. You will see “Category” in the bottom left of the display.
To adjust XM radio volume
Press volume up or volume down to achieve the desired XM volume
level. Note: MOH level, XM Stereo outputs, and XM input volume con trols
are affected by this volume control. The overall amplifi er volume is not
affected by this volume control.
To mute the XM signal
Press Mute. “Mute” will fl ash in the display to notify you that audio is
muted.
To adjust the LCD screen contrast
1. On the remote, hold Volume down and press the Category > button.
2. Adjust contrast up and down using the Scroll encoder.
3. Press Menu to exit.
2. Press CH+ or CH– to cycle through the channels.
3. Press OK to select the desired channel.