Filter
Top Products
© 2005 Directed Electronics, Inc.
6. Cut a 1" hole in the headliner along the backside of the mounting bracket for the cables to
pass through.
7. Route cables through the hole to the predetermined location of the AV source(s).
8. Identify the dome light wires in the vehicle and connect them to the corresponding dome light
wires on the overhead monitor system. Ensure the domelight switch is in the correct position.
9. Plug in the DIN, Dome Light cable and Secondary power cables into the overhead monitor system.
10. Carefully hold the overhead monitor system to the mounting bracket aligning the mounting
holes while screwing in the screws. (Make sure the wires and cables are not in the way while mount-
ing the monitor).
11. Connect the Secondary Power cable from the monitor to the A/V switch box.
12. Ground the Black wire of the power cable to a clean ground spot.
13. Connect the Yellow wire of the power cable to the battery positive terminal.
14. Connect the Red wire of the power cable to the Accessory wire in the ignition harness.
NNOOTTEE::
Make sure you keep the ground wire of the monitor and video source as short
as possible to prevent unwanted audio noise pickup from the vehicle’s systems.
Roof Beam Support
Metal Bracket
Optional Spacer Material
(Installer Provided)
Screws
(not included)
Screws
(Included)
22