Filter
Top Products
26D-Link DCS-910/920 User Manual
Section 3 - Configuration
Setup > Wireless
Service Set Identifier, an identifier for your wireless network.
The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When there is
interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum performance
for your connection.
Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hoc is a wireless
connection used without an access point, where your DCS-920 is directly connecting to your PC. This is done using the on-
board wireless adapter on the DCS-920 connected to a wireless adapter on the PC.
This page will allow you to select a wireless network that the DCS-920 was able to detect upon booting up.
For security, there are three choices; None, WEP, and WPA-PSK / WPA2-PSK. Select the same encryption method that is being
used by your wireless device/ router.
An appropriate Preshared Key, which is needed in order to connect to the wireless network..
SSID:
Channel:
Connection Mode:
Survey:
Wireless Security
Mode:
WPA-PSK / WPA2PSK
Settings:
Wireless Interface
In this section, you can setup and configure the wireless
settings on your camera.
Note: Wireless is available only for the DCS-920.