Filter
Top Products
T
7"
~"
-~~:i"
~ ~5rf:;~tC .","
~",,~' ,~~
8. Carefully trim headliner and drill (2) two Y2"
holes in return air grille to allow for screws to
pass through when mounting bracket. See fig. 4.
FIGURE 4
T 1
t~
9. Install rear mounting bracket (item 6 pg 2) and
secure using (4) four # 8 x 3,{" screws (item 2
pg 2). Make sure that holes in bracket align
with dimples in roof brace. See figure 5.
'--"-
FIGURE 5
~
f
;:
L
II. PREPARATION OF CONSOLE FOR INSTALLATION
.f
~
ii
W
~ ~
10. Install the video system in console and secure
using hardware supplied with video system.
Start all screws before tightening. Be~n with
the rear center screw, then alternately tighten
screws around the perimeter of pod. See figure
6. Refer to owner's manual supplied with
video system. Caution: Do not overtighten
screws.
~.
,\
~
, I
FIGURE 6
4