Filter
Top Products
f
~
:;:
...
~
'.
~
~
rf
~-
J
III. INST ALLA TION OF CONSOLE
" " " .
NOTE: Additional a"ssistance in mounting the overhead console in vehicle is
advised to prevent damage to console or components.
c
13. Install and route all accessory wiring, video
and audio cables, and any other added
component requirements to their respective
places in the vehicle. Refer to component
installation instructions for wiring diagrams.
The suggested routing of the video system
cable is as follows: Above the headliner from
video system to B-pillar. Down the B-pillar
to the floor. Route the power lead to an
accessory controlled source. Connect the
ground lead to the vehicle chassis. Route the
remaining wiring (RCA plugs, Remote
Sensor extension, etc.) to the VCP location.
See figure 12. Connect per instructions
included with the video system. Ifvideo
system if to be used as a television, install an
appropriate antenna per instructions included
with the antenna.
;t
~
r.
t
f
Figure 12
14. Raise console into approximate position and
connect all wiring to components. Connect
wiring aI)d cabling to video system per
instructions included with \'ideo system.
15. Check function of all components and lights.
See operating instructions for video system
operations check. For further assistance, refer
to the video system manual for the technical
support phone number listed for your area.
16. Carefully position console against headliner.
Release video screen from locked position.
Lower video screen to viewing position for
access to mounting locations in top of video
system housing and align holes in housing
with holes in rear mounting bracket. Secure
using (4) four # 6 x Y2" screws (item 1 pg 2).
See figure 13.
0;
ii
.
"'
Figure 13
Caution: Do not overtighten screws. Use extra support for the console until secured to the
vehicle. Failure to do so may cause damage to console or installed components.