Filter
Top Products
4
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
Insert the supplied keys into the left and right sides as shown, and slide the unit out of the mounting sleeve.
Mounting Options
1. Rear ISO-DIN (using OEM factory radio mounting brackets):
• Remove factory radio mounting brackets and attach to the left and right sides of the XDVD8265 chassis.
• See diagram on page 5.
2. Rear ISO-DIN (using included universal mounting brackets):
• Attach left and right mounting brackets to the left and right sides of the XDVD8265 chassis
.
• See diagram on page 5.
3. Front load (using mounting sleeve):
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna as shown on
pages 6-7. Consult a qualified technician if you are unsure.
• Certain vehicles may require a wiring harness adapter (sold separately).
• Test for correct operation and mount the XDVD8265 according to your application.
• The trim ring may be required for some applications. Using a utility knife, score the trim ring on the back side to
trim the depth and width as needed. Use the supplied 4 strips of double-sided tape to attach the trim ring.
• Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or #2 x 3/8” Phillips
head screws.
XDVD8265 INSTALLATION
Preparation