Dual XDVDN8290 Car Video System User Manual


 
5
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
• Insert the supplied keys between the radio and the sleeve at the left and right sides, and slide the unit out of the
mounting sleeve.
Mounting Options
1. Rear ISO-DIN (using OEM factory radio mounting brackets):
• Remove factory radio mounting brackets and attach to the left and right sides of the XDVDN8290 chassis.
• See diagram below.
2. Front load (using mounting sleeve):
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna as shown on pages 6-7. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Test for correct operation and mount according to your application.
• If required, snap desired trim ring into place.
• Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or Phillips head
screws.
XDVDN8290 INSTALLATION
Preparation
Mounting the XDVDN8290 using OEM factory
mounting brackets.
Mounting the XDVDN8290 using mounting
sleeve (front load).