DPA 4410 POWER AMPLIFIER
Features
• 4 x 100 W output capacity
• off ground potential 100 V outputs (internally configurable to 70 V/50 V or 4 ohms)
• all outputs are protected against floating (no load) and short-circuit
• mains supply 115/230 V AC or battery operation 24 V DC
• mains switch 115/230 V
• REMOTE CONTROL start with STANDBY indicator (mains and battery operation)
• service mains switch
• GROUND-LIFT switch
• active ventilated through a temperature-controlled DC ventilator
• electronically balanced inputs
• routing switch for parallel operation of the amplifier inputs
• input level control
• power-on noise suppression
• 3 LED indicators with CLIPPING indicator for metering purposes
• MONITOR outputs
• temperature control with PROTECT indicator
• fault indicators: READY and GROUND FAULT
• fault message via off potential READY contact
• TEST switch for pilot tone surveillance and GROUND FAULT reset
• off ground potential, balanced input transformer are optionally available
• pilot tone surveillance module and ground fault surveillance module are optionally available
• 19" rack dimensions with 3 HU
OWNER’S MANUAL
17