Filter
Top Products
8
Notes:
BATTERIES
Do not direct the remote sensor toward
any light source, such as direct sunlight or
a strong fluorescent light, as it may cause
the unit to not operate correctly.
When other remote controls are used
nearby or when the remote is used near
may occur.
Placing an object on the remote control
may cause it to inadvertently depress a
battery life.
Do not glaze the front of the DVD receiver
with colored glass, as it may cause
interference with normal operation of the
controller.
Make sure there is no barrier between the
remote control and remote sensor, as it
could prevent the unit from receiving the
signal.
Do not spill water or put wet items on the
remote control.
Never disassemble remote control.
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE OR EXP
LODE.
equipment using infrared rays, interference
button, changing a function and shortening
1. Push down and out on the battery Compart-
ment cover to remove it.
2. Insert the two AAA batteries into the battery
compartment of the remote control, making
sure the + and - signs on the batteries and
inside the battery compartment match up.
3. Replace the battery compartment cover.
Do not mix batteries from different manu-
facturers, nor old ones with new.
If the remote control will not be used for an
extended period of time, remove the
batteries to prevent damage-causing
corrosion.
Remove dead batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from the battery compartment, then
replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
Life expectancy of batteries may vary
depending on amount of use.
Point the remote control at the remote sensor
on the DVD receiver. When the signal is
received from the remote, the unit will function
accordingly. The remote will operate to
approximately 16' from the remote sensor at an
angle of around 30 each direction.
Battery Installation
Using the Remote Control
Notes:
""
1. Push down and out on the battery Compart-
ment
cover to remove it.
2.
Insert the two AAA batteries into the battery
compartment
of the remote control, making
sure
the + and - signs on the batteries and
inside
the battery compartment match up.
3.
Replace the battery compartment cover.
Do
not mix batteries from different manu-
facturers,
nor old ones with new.
If
the remote control will not be used for an
extended
period of time, remove the
batteries
to prevent damage-causing
corrosion.
Remove
dead batteries immediately to
prevent
damage-causing corrosion.
If
battery leakage occurs, wipe the battery
liquid
from the battery compartment, then
replace
both batteries.
Always
replace both batteries at the same
time, using
new, fully charged batteries.
Life
expectancy of batteries may vary
depending
on amount of use.
Point
the remote control at the remote sensor
on
the DVD receiver. When the signal is
received
from the remote, the unit will function
accordingly. The
remote will operate to
approximately
16' from the remote sensor at an
angle
of around 30 each direction.
Battery Installation
Using
the Remote Control
Notes:
OPERATING THE
REMOTE CONTROL