Ericsson RX8320 Car Satellite TV System User Manual


 
Quick Start Guide: Connect-Power-Configure
4. During initialization, confirm that the Status LED is on and all Up, Down, Left,
Right, Edit and Save pushbuttons are lit.
3.2.2 Power Up Operating Modes
When the equipment is switched on it will assume the control mode that was set
when the power was turned off.
3.3 Configuring the Inputs
3.3.1 Transport Stream (ASI) Input
To configure the unit for ASI input:
1. Select ASI input from sub-menu 2.1Select Input.
3.3.2 8-VSB Input
To configure the unit for a Vestigial Sideband (VSB) modulated input:
1. Select VSB input from sub-menu Select Input.
2. Select channel/frequency from the sub-menu 8VSB.
3. Select Direct Frequency/Auto Tune enable/disable from sub-menu 8VSB CTRL.
3.4 Selecting a Decode Service (Program)
To select a decode service:
1. Navigate to the Service menu. For incoming feeds containing only a single
service the service may be selected automatically depending on service
selection control.
2. If the service is NOT selected, press Edit and, using the S (Up) and T (Down)
pushbuttons in the decode service sub-menu, scroll through the service name
list.
3. Press Save to select the required service.
Note: If the unit has successfully selected a service, then the Service ID and
Service name should be displayed in the Service menu.
3.5 Configuring the Video Output
When configuring the Video Output, the following points should be observed:
EN/LZT 790 0008/2 R1A 2011-03-30
11 (36)